2 part polymer modified cementitious waterproof mortar slurry
Comprising of a liquid polymer and a cement based mix incorporating special admixtures
It is applied to concrete and mortar to prevent water infiltration
SIKA WATERPROOFING CEMENT RTC Import this type civil Product
USES: SikaTop Seal-107 is used for:
Interior and exterior waterproofing and damp-proofing of concrete, cementitious rendering, brickwork and blockwork
Protection of concrete structures against the effects of de-icing salts and freeze-thaw attack
Exterior waterproofing of basement walls in new construction and refurbishment
Pore / blowhole filling
Rigid waterproofing of water tanks, swimming pools, etc.
Sealing fine “hairline” cracks in concrete structures not subject to movement
Sealing internal basement walls against dampness
Leveling mortar for concrete repair works
Potable concrete water tanks
Terraces and balconies
Swimming pools and fountains
RC gutters and planter boxes
CHARACTERISTICS AND ADVANTAGES:
Pre-batched components – mixes and applies easily
Slurry or trowellable consistency
Good adhesion to sound, prepared substrates
Increased frost and salt resistance
Protects against concrete carbonation and water penetration
Non toxic – suitable for contact with drinking water
Non corrosive to steel and iron
Part A: white liquid Part B: Grey powder Part A+B: Grey slurry
PACKAGING: SIKA WATERPROOFING CEMENT is Two Type
Type-A 20kg, Type -B 5kg
Coverage Depending on type of application, two (2) coats always required. Three (3) coats may be required in areas of extremely high infiltration.
– 1st coat consumption 1-1.5 kg/m2 on damp surface.
– 2nd coat consumption 0.8 – 1 kg/m2 approx.
Surface Preparation Concrete, mortar and masonry surfaces must be clean, free from grease, oil and loosely adhering particles. All surfaces must be as true and flat as possible. Saturate absorbent surfaces thoroughly with water before application.
The consistency of the mix can be altered by reducing the amount of component (A) (liquid) to be used. Under normal circumstances, when the full quantities of both components are mixed together, a slurry consistency will result. For a trowelable consistency use only 90% of component (A) (approx. 4.5 kg) Mix in a clean container by slowly adding the powder component to the liquid component and stirring with slow speed mixer.